seedstpprotocol:control_using_stp

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
seedstpprotocol:control_using_stp [2017/09/27 18:09] – [FAQ / Troubleshooting] Pedro Ramiloseedstpprotocol:control_using_stp [2017/11/02 13:22] (current) Pedro Ramilo
Line 101: Line 101:
  
  
-==== Online Diagnostics and Maintenance ====+==== Extended commands for Online Diagnostics and Maintenance ====
  
 The Console exposes specific command to assist in diagnosing your unit and re-configuring some of the options on the fly. The Console exposes specific command to assist in diagnosing your unit and re-configuring some of the options on the fly.
  
-The go-to commands for Diagnostics are ''status'' and ''about''.\\+The go-to commands for Diagnostics are ''status'' and ''about''. 
 The ''restart psu'' command helps you clear overload errors in the Internal Actuators without having to reset power on the entire bus. This is done by restarting only the built-in PSU that regulates power to the internal Actuators. The ''restart psu'' command helps you clear overload errors in the Internal Actuators without having to reset power on the entire bus. This is done by restarting only the built-in PSU that regulates power to the internal Actuators.
  
-For a complete reference, please see the [[eros:consolecommands|List of Console Commands (for EROS architecture)]]+The ''setfan'' command helps you adjust the units' fan speed (on supported models) to improve thermal behaviour or reduce noise (depending on the usage scenario). 
 + 
 +For a **Complete list of commands**, please see the [[eros:consolecommands|List of Console Commands (for EROS architecture)]]
  
 ==== FAQ / Troubleshooting ==== ==== FAQ / Troubleshooting ====

Copyright © 2015-2023 Seed Robotics Ltd

  • seedstpprotocol/control_using_stp.txt
  • Last modified: 2017/11/02 13:22
  • by Pedro Ramilo