Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
seedstpprotocol:control_using_stp [2017/09/27 14:08]
pedro.ramilo [FAQ / Troubleshooting]
seedstpprotocol:control_using_stp [2017/11/02 09:22]
pedro.ramilo
Line 101: Line 101:
  
  
-==== Online Diagnostics and Maintenance ====+==== Extended commands for Online Diagnostics and Maintenance ====
  
 The Console exposes specific command to assist in diagnosing your unit and re-configuring some of the options on the fly. The Console exposes specific command to assist in diagnosing your unit and re-configuring some of the options on the fly.
  
-The go-to commands for Diagnostics are ''​status''​ and ''​about''​.\\+The go-to commands for Diagnostics are ''​status''​ and ''​about''​. 
 The ''​restart psu''​ command helps you clear overload errors in the Internal Actuators without having to reset power on the entire bus. This is done by restarting only the built-in PSU that regulates power to the internal Actuators. The ''​restart psu''​ command helps you clear overload errors in the Internal Actuators without having to reset power on the entire bus. This is done by restarting only the built-in PSU that regulates power to the internal Actuators.
  
-For a complete reference, please see the [[eros:​consolecommands|List of Console Commands (for EROS architecture)]]+The ''​setfan''​ command helps you adjust the units' fan speed (on supported models) to improve thermal behaviour or reduce noise (depending on the usage scenario). 
 + 
 +For a **Complete list of commands**, please see the [[eros:​consolecommands|List of Console Commands (for EROS architecture)]]
  
 ==== FAQ / Troubleshooting ==== ==== FAQ / Troubleshooting ====
  
-  * I get no reply when I send a command: you must terminate your commands with a ''​\n''​ (also called "Line Feed"​). ​+  * I get no reply when I send a command: you must terminate your commands with a ''​\n''​ (also called "Line Feed (LF)" ​or "​Newline"​ in other software packages). 
  
 If you are using a Serial Terminal make sure it set to use ''​\n''​ as a line terminator. If you are using a Serial Terminal make sure it set to use ''​\n''​ as a line terminator.

Copyright © 2015-2019 Seed Robotics Ltd

  • seedstpprotocol/control_using_stp.txt
  • Last modified: 2017/11/02 09:22
  • by pedro.ramilo