fts:fts1_pressuresensor

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
fts:fts1_pressuresensor [2021/06/01 15:05]
SeedR KB Admin [User commands]
fts:fts1_pressuresensor [2021/06/01 15:06] (current)
SeedR KB Admin [User commands]
Line 129: Line 129:
  
 ''setepoch,seconds,milliseconds'' – sets the DAQ timestamp (columns 2 and 3 of each line of data output by the DAQ).\\ ''setepoch,seconds,milliseconds'' – sets the DAQ timestamp (columns 2 and 3 of each line of data output by the DAQ).\\
-This can be used to set a real time that is then sent with each record. The purpose is to help synchronize multimodal datasets.+This can be used to set a real time that is then sent with each reading. The purpose is to help synchronize multimodal datasets.
  
 ''setperiod,milliseconds'' – sets the data output period, which implicitly sets the output framerate. Valid settings are any number between 20 and 1000 where a period of 20ms corresponds to a frequency of 50Hz and period of 1000ms corresponds to 1Hz ''setperiod,milliseconds'' – sets the data output period, which implicitly sets the output framerate. Valid settings are any number between 20 and 1000 where a period of 20ms corresponds to a frequency of 50Hz and period of 1000ms corresponds to 1Hz

Copyright © 2015-2020 Seed Robotics Ltd

  • fts/fts1_pressuresensor.txt
  • Last modified: 2021/06/01 15:06
  • by SeedR KB Admin