Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
fts:fts1_pressuresensor [2021/05/25 13:10] – SeedR KB Admin | fts:fts1_pressuresensor [2021/06/01 15:06] – [User commands] SeedR KB Admin | ||
---|---|---|---|
Line 108: | Line 108: | ||
==== User commands ==== | ==== User commands ==== | ||
- | The connection to the DAQ is established in full duplex mode, which means the user can send commands | + | The connection to the DAQ is established in full duplex mode, which means that for most commands, |
- | IMPORTANT: | + | IMPORTANT: |
User commands are sent in text mode (ASCII) directly to the same serial port where the DAQ data is being output. | User commands are sent in text mode (ASCII) directly to the same serial port where the DAQ data is being output. | ||
Line 129: | Line 129: | ||
'' | '' | ||
- | This can be used to set a real time that is then sent with each record. The purpose is to help synchronize multimodal datasets. | + | This can be used to set a real time that is then sent with each reading. The purpose is to help synchronize multimodal datasets. |
'' | '' |
Copyright © 2015-2023 Seed Robotics Ltd