rh7d:unpacking_mechanical_assembly

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revisionBoth sides next revision
rh7d:unpacking_mechanical_assembly [2021/11/05 15:57] SeedR KB Adminrh7d:unpacking_mechanical_assembly [2021/11/05 15:57] SeedR KB Admin
Line 28: Line 28:
  
 The hand is assembled by means of 4-6 screws located on the back ("wrist") position. The hand is assembled by means of 4-6 screws located on the back ("wrist") position.
-These screws are designed with common spacing in mind, being compatible with assembly on Darwin-OP/Robotis OP2 (for OP assembly instructions, see below). 
  
 {{:dh4d:assemblybracketdimensions.png?nolink&300 |}}{{ :dh4d:screws.png?nolink&300 |}} {{:dh4d:assemblybracketdimensions.png?nolink&300 |}}{{ :dh4d:screws.png?nolink&300 |}}

Copyright © 2015-2023 Seed Robotics Ltd

  • rh7d/unpacking_mechanical_assembly.txt
  • Last modified: 2021/11/05 15:58
  • by SeedR KB Admin