rh7d:unpacking_mechanical_assembly

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
rh7d:unpacking_mechanical_assembly [2021/11/05 15:57]
SeedR KB Admin
rh7d:unpacking_mechanical_assembly [2021/11/05 15:58] (current)
SeedR KB Admin
Line 33: Line 33:
 Assembly screws are already pre-assembled (in green). Remove them, including the washers. Assembly screws are already pre-assembled (in green). Remove them, including the washers.
 Pay attention to NOT remove the screws in red or any other screws and they are structural to the hand assembly. Pay attention to NOT remove the screws in red or any other screws and they are structural to the hand assembly.
- 
-To prepare the assembly, align parts as seen in the next picture (here we show a sample bracket). 
- 
-{{ :dh4d:bracket-orientation.png?nolink&300 |}} 
  
 The wrist rotation has approximately 180º of range. Therefore, for correct assembly, rotate central hub in the direction marked in the picture according to the side on which you are assembling: left hand or right hand. The wrist rotation has approximately 180º of range. Therefore, for correct assembly, rotate central hub in the direction marked in the picture according to the side on which you are assembling: left hand or right hand.

Copyright © 2015-2020 Seed Robotics Ltd

  • rh7d/unpacking_mechanical_assembly.txt
  • Last modified: 2021/11/05 15:58
  • by SeedR KB Admin